DAC/DAC 8-Bit µP Compatible, Double-Buffered D to A Converters. General Description. The DAC is an advanced CMOS/Si-Cr 8-bit multiplying . As the name itself points out ‘DAC’ is a DAC chip or Digital to Analog Conversion IC. The device is from DAC series that are 8-bit. DAC/DAC 8-Bit μP Compatible, Double-Buffered D to A Converter Data LM Operational Amplifier Data Sheet, National Semiconductor Corp.
|Published (Last):||23 July 2015|
|PDF File Size:||4.92 Mb|
|ePub File Size:||20.58 Mb|
|Price:||Free* [*Free Regsitration Required]|
DAC 데이터시트(PDF) – National Semiconductor (TI)
Submitted by admin on 21 November We can use the circuit to develop applications without worry as the circuit is tested working. So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in circuit diagram.
This op-amp datsheet is called current-to-voltage converter. DAC IC basically used in applications where catasheet 8 bit digital data needed to be converted to analog value. This also permits the simultaneous updating of any number of DACs.
The device is available in the market for low cost and can be easily worked datashfet. The design also includes special circuitry that provides TTL logic input voltage level compatibility.
Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word. DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0.
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. Now for understanding the working let datqsheet consider the example application circuit given in the datasheet.
The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors. TL — Programmable Reference Voltage. Pin Configuration Dxtasheet is a twenty pin device and description for each pin is given below. This analog signal is the current quantity that is directly proportional to the input digital value and this current parameter needed to be converted in to voltage parameter for further use.
All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. For working of device DAC we have connected a voltage source of 15V as shown in diagram.
DAC Technical Data
DAC datzsheet in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output. The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors. So the device is used for converting 8 bit parallel digital data input to analog signal output.