Autotrol i Manual – Free download as PDF File .pdf), Text File .txt) or read online for free. Valve Exploded View. Valve Parts List. Performa Exploded View. Performa Parts List. Logix Series Controllers Parts List. TROUBLESHOOTING. SWT’s online PDF library of Autotrol Control Valve Installation, Operation, Logix Operation Manual (Models: Twin Alternating, Twin.
|Published (Last):||5 June 2007|
|PDF File Size:||7.56 Mb|
|ePub File Size:||12.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
It sounds like there is leakage past the 2 and possibly the 3 flapper valves and these are the two main valves.
Can you hear the valve move if you shake the valve body? There is no check valve anywhere inside the Autotrol I have a steady, but slow stream of water little more than a trickle coming through the drain line. I replaced all the flapper valves and everything works fine now. While looking at the parts brake down of that valve, I see that there are some O rings between the two parts.
It sounds as if you need a set of new flapper valves, especially the brine pair. You don’t need any new module etc.
My main problem is iron, I thought about soaking it in a heavy concentrate of super iron out for a couple of days. I have soaked it in Iron out, flushed it, cleaned the flapper valves, screen, injector valve basically everything that can come apart has come apart and been cleaned. What kind of water quality are you deal with? I’ve cleaned the little screen and the injector – and I’ve cleaned the air check valve base. Any advice would be greatly appreciated!
I will have to check one of the valves that I have in the pile, see what it sounds like. After putting it back together and installing it back on the tank it still won’t siphon brine and actually water comes out of the brine well tube. All times are GMT The only “check valve” is the black rubber ball in the air check on the right side facing the control.
When it is free anyway. I will let you know the results, thanks.
Water Softener Manual | Autotrol | Aqua Tech Water
I have an Autotrolthe problem I am having is it is manua, drawing brine in fact during the brine cycle it flows a small amount of water into the brine tank instead of creating the suction needed to draw brine out of the tank. So I will get a rebuild kit and try that.
Originally Posted by kpreilly. I’ve never seen a bad ball.
Thanks for all the helpful advice. I also was going to buy a rebuild kit but don’t want to waste the money if I need to replace the valve assembly.
The Autortol part number of ATthe valve body that sets on top of the tank adapter module looks to be around Is there anything inside the valve that I cannot get to that might be clogged or stuck and if so what can I do about it? Autltrol air check is where the brine line going to the salt tank is connected to the control valve on top the air check.
With all of the flappers and other parts off one might be able to mankal soaking it in some thing like iron out. In what area is the check valve and is there anything that it can be soaked in to clean it out like Iron out. I have taken the control valve off numerous times, disassembled it and cleaned it as best I can.
If the ball doesn’t seal against its seat you may get mmanual into the salt tank. I remember seeing it in the old manuals where it showed a check valve but no real clear way to get to it.
If I need one do you have a valve that can be rebilt, or how much is a new valve without the timer. Autotrol won’t draw brine Printable View. I also have an Autotrol – and the brine tank is consistently overfilling. The time now is Yes I agree, I disassembled the valve, again, and soaked everything in a concentrated solution of Iron out and it is clean.